|
Who's Online
There currently are 5909 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I liked the product. I would use their sevices again.
;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
14VT-L100T
ELECTRICAL TROUBLESHOOTING
VCR POWER TROUBLESHOOTING The VCR is dead.(No power) FLOW CHART NO.1-1 KEY-IN TROUBLESHOOTING Key-in input for VCR is not received. FLOW CHART NO.1-2
Unplug the AC power cord. Replug it a few minutes later. YES Are the AT 5V and AT 12V NO lines normal? YES Are the AT 5V and GND lines properly connected with IC7701? YES Is there oscillation (16MHz) at pins (38) and (39) of IC7701? YES NO Check/replace X7701 and/or IC7701. NO Check power circuit.
Is the key switch in good contact? YES Is there short-circuit in the key input? YES Check poor soldering. Are signals received at pin (27) of IC2001 when the key is activated? YES Check IC7701, IC2001 and signal line of serial datas, serial clock and ready (L).
NO
TROUBLESHOOTING OF VCR SECTION
Check the switch contact.
NO
Check IC2001 and switches for poor soldering.
NO
Check key lines to input IC2001.
40
Does the "L" pulse of syscon reset appear at pin (43) of IC7701 after the AC cord is plugged in? YES Does pin (21) of IC7701 change from "L" to "H" level when the power button is pressed to turn on the power? YES Are the PC 9V and PC 5V lines normal? YES Check the sensor inputs to IC7701 from mechanism. (CAM switches,start/end sensors,and reel sensors)
NO
Check the signal line of sys-con reset all the way up to pin (22) of IC2001.
NO
Check the power key input to IC2001 and serial datas/clocks between IC2001 and IC7701.
NO
Check power circuit.
|
|
|
> |
|