|
|
|
Who's Online
There currently are 5865 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Excellent service manual includes everything is need to repair this radio-caseete, how to disassemble, wiring diagram, all , waiting time until the download was only a few hours. I'm going to buy service manuals from here, are cheap and very good.Thank you.
;
Good service manual,i saved from scrapping this deck,is now fully functional.Thanks.
 ;
Found this to be the manual included with the original packinging, was helpfull but did not give any detailed repair instructions.
;
Complete service manual, was very helpful in repairing this tapedeck.Thanks.
;
The service manual was a copy of the original from Wirlpool. The quality was good, all neccecary information was available including the service-codenumbers, so I could order the right part to be replaced for repair.
Downloding was no probem after the payment.
Thanks for the service!
14VT-N10T(S)
INSTALLING THE MASTER CAM (AT REAR SIDE OF MECHANISM CHASSIS)
1. Make sure beforehand that the shifter is at the point as shown below. 2. Place the master cam in the position as shown below.
E-ring (XRESJ30-06000) Master cam
REPLACEMENT OF LOADING MOTOR
� Removal
Apply grease Apply grease
Fully turn clockwise
No grease Fully turn counterclockwise Face the wide tooth side ward
Figure 1-44-1. Note: See the figure below for the phase matching between the master cam and the casecon drive gear. 3. Finally fix with the E-ring. � Replacement 1. Remove the loading motor, and install the replacement loading motor as shown below.
Figure 1-45.
Master cam
Casecon drive gear 10.2 +0.2 mm
�0.2
Half-round notch Round mark
When installing the master cam, align the casecon drive gear round mark with the half-round notch of master cam.
Figure 1-46.
Figure 1-44-2.
The loading motor pressing-in must be less than 14.7 N (15 gf). Adjust the distance between motor and pulley to 10.2 +0.2 mm).
�0.2
36
|
|
|
> |
|
