|
|
|
Who's Online
There currently are 5411 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
;
the manual is great and especially hard to find... thanks for the great service and having a hard to find manuel_
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.50 of store credit for Your review.
;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
28JW-76E
contained in an �.hex� file. This file must conform to the Intel HEX-32 format. The software does check whether the program operation has been successful or not. 1 Installation of �Tiny M2Flash�: 1.1 Place the �.obj� file in �C:\�. 1.2 Place the �.exe� file anywhere. 2 �Tiny M2Flash� usage: 2.1 Choose the serial port number that this instance of the program will use to communicate with the digital module. 2.2 Browse the file system and choose the �.hex� file that contains the information to be written into the flash. 2.3 Tie pin 3 of connector YB at the digital module to ground. Turn on the 3.3 V power supply that feeds the digital module. This will make it reset. 2.4 Press the �PROGRAM� button once. This will automatically: 2.4.1 Open the serial port. 2.4.2 Send the (machine code) �server� program to the M2 microcontroller. The PC will act as the �client.� 2.4.3 Erase the whole flash chip. 2.4.4 Program the flash with the information contained in the �.hex� file. 2.5 If needed, the button �STOP� can be pressed to stop the execution of that instance of the program in the PC. However, this will not necessarily interrupt whatever the M2 was doing. It is recommended that the digital module be resetted after �STOP� has been pressed in the program. 2.6 The program will display the message �OK� or �ERROR,� depending on whether the programming operation has been successful or not. 2.7 Turn off the power supply.
Figure 20: Screenshot of Tiny M2Flash. Note: The progress bar starts growing right after the flash memory has been erased.
82
|
|
|
> |
|
