There are currently no product reviews.
VERY NICE FOR COURTESY AND PRECISION!.
tHE SITE IS VERY IMPORTANT FOR ALL DEVICES
+++ Is is fine, that was what i looking for. Thanks! +++
A very good complete archive, i am very satisfied for document.
The Service Manual received was helpful. The electronic information is exactly what I needed.
The Manual was perfect.
The deliverie was perfect.
The model is a mixture of the adjustment items of I2C BUS-CONTROL and the existing analog adjustment. Moreover, since the adjustment with I C BUS-CONTROL is composed of the items which are set with the initial values (preset values) alone and the data variable items, refer to the following.
!"#$%fO` ! !"#$%&'()"*+#$,-./012345fO` 89:; !"#$ <=>?@ !"#$%&'()*+,-.)/-.01234567012
1 2 3 4 5 pbq=rm oL` oL` oL` pbq=rm !PRN PRO !"# $%&'()*+,-fO` !"#$
1) Setting method to the microprocessor service mode
1 When the jumpers 351 and 352 of SET UP are short-circuited, enter into the service mode (I2C BUS CONTROL adjustment mode). 2 The modes can be sequentially selected with the CH DOWN key of R/C. 3 The modes can be sequentially selected in the reversed order of 2 with the CH UP key of R/C. 4 The data can be converted with the VOLUME UP/DOWN key of R/C. 5 When the short circuit between the jumpers 351 and 352 of the setup is cut off, it will be released from the service mode.
!"E`e=rmF !"#2 !"#$%&'()* !"L Eslirjb=rmLaltkF !"#$%&' !PRN PRO !" #$%&'()*+,-./
2) Initial value (preset value) setting
1 When the MAIN POWER switch set at the service mode side is turned on, the initial value will be automatically set only on the new E2PROM (discriminated with the head 4 bytes). 2 The initial data is set as shown in the attached sheets. 3 Take care that there are the items which need be changed and the items in which the initial values continue set.
!"#$%&'()*$Q !"#$%&'()*!"+,-./0 !"#$%&'()*+,!"#$%&'()*+,-.&/01()*2345678