There are currently no product reviews.
Even if the PDF is a scan, I can read the information I need.
The price is affordable and the service (mail sending) is very fast.
Thanks ! Regards. William (Fan of Kenwood)
Very good quality original datasheet!I like this amazing website!!!!!!
Excellent just what I needed to replace the electrolytic caps and make this old gem a beauty again. Was as scan of the original photocopied service manual.
It was helpful to get schematic with waveforms in important points and lot of service information. Manual is good quality, fast delivered. Of course it is hardcopy of paper one with all its disadvantages.
I want to give you a real heads-up for your desire to enable such people as I to acquire the information I need to maintain the older types of equipment such as this Akai HXA351W. You do a swell job with all the processes you have to perform so I can have a legible, thus usable
document which does not send me crazy trying to figure out the blurry text of a bad copy.
Very well done, Thomas.
DESCRIPTION OF SCHEMATIC DIAGRAM
SAFETY NOTE: 1. DISCONNECT THE AC PLUG FROM THE AC OUTLET BEFORE REPLACING PARTS. 2. SEMICONDUCTOR HEAT SINKS SHOULD BE REGARDED AS POTENTIAL SHOCK HAZARDS WHEN THE CHASSIS IS OPERATING.
60FW-53E 70FW-53E 81FW-53E
NOTE: 1. The unit of resistance Â«ohmÂ»is omitted (K=1000 ohms. M= Megaohm). 2. All resistors are 1/8 watt. unless otherwise noted. 3. All capacitors are ÂµF, unless otherwise noted (P= ÂµÂµF). 4. The capacitor with Part No. RC-FZ9XXXBMNJ is designed to with stand 63V.
IMPOTANT SAFETY NOTE: PARTS MARKED WITH Â« Â»( ) ARE IMPORTANT FOR MAINTAINING THE SAFETY OF THE SET. BE SURE TO REPLACE THESE PARTS WITH SPECIFIED ONES FOR MAINTAINING THE SAFETY AND PERFORMANCE OF THE SET. SERVICE PRECAUTION: THE AREA ENCLOSED BY THIS LINE ( ) IS DIRECTLY CONNECTED WITH AC MAINS VOLTAGE. WHEN SERVICING THE AREA, CONNECT AN ISOLATING TRANSFORMER BETWEEN TV RECEIVER AND AC LINE TO ELIMINATE HAZARD OF ELECTRIC SHOCK.
CAUTION This circuit diagram is original one, therefore there may be light difference from yours.
WAVEFORM MEASUREMENT CONDITION: Colour bar genetator signal of 70 dB from RF input.
1.3 KV 15.625KHz
4 Vp-p 15.625KHz
41 Vp-p 15.625KHz
45 Vp-p 113 KHz FM
20.5 Vp-p 50Hz
1.15 Vp-p 15.625KHz