|
|
|
Who's Online
There currently are 5993 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Nice to have the service manual for the Sony DCR-TRV345E now. The document is of excellent quality.
 ;
MACKIE HR824 26 pages English-only Service Manual contains:
1) HR824 technical overview with the description of front and rear panel switches.
2) HR824 specs
3) Block Diagram
4) Wiring Diagram
5) Packaging management
6) Spare part & final assembly list (for PCB rev A and B) + exploded view
7) Test Procedures (where, how to measure voltage...) including Test Point diagram on the PCB.
8) IC and Transistor charts.
Excellent guide: very clear, good scan quality enabling us to print readable diagram :-)
Note:
Mackie HR824 make extensive use of surface mount devices (SMD). Service on the HR824 must
only be undertaken by experienced service technicians with the right tools, experience and patience to perform surface mount rework when needed.
;
This Service manual is very well scanned and its clean to read, no any anti-theft words that un-english could understand. I got my CCD600 working with this manual and it´s clear shematics :)
;
I was very pleased with the service provided and was surprised at how good the quality was of the manual. I thought it may be a third generation copy or so, but it is as good as the websites that charge 3 times this much. I repair some electronics for family and friends without charge, so this is perfect for me. Thank you very much.
;
The service was great and the document was also great. Highly recommend!!!!
If anyone has a users manual... Please email me. need one. $ [email protected]
AH-A126E AU-A126E
14-2 TEST 2 (For output of each operation checking) Test mode is for checking output of each operation. Keep pushing both the buttons, "AUX." and "TEST RUN", and supply the power, the system will go to the test 2 mode. In this mode, the output of operation is switched by the "TEST RUN" button in the unit or the "OI" button in the remote controller. Use the "AUX." button to back to step 1. Normal outputs are shown in Table H-5. Table Y-5
Lamps Step 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Output for outdoor unit OFF ON OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF (Back to step 1) 1 : 7�C : 7�C 2 : �2�C : �2�C 3 : 0.1V : 0.1V Room temp. 42�C (Room temp.) or (Room temp.) Pipe temp. 42�C (Pipe temp.) or (Pipe temp.) ON OFF ON OFF ON OFF RED 1 Flickering ON ON ON ON OFF ON ON ON ON OFF OFF ON ON OFF ON OFF ON ON ON OFF 5 YELLOW 2 ON OFF ON ON 3 ON OFF ON OFF 6 OFF ON OFF ON OFF OFF ON OFF OFF ON ON OFF 4 Indoor Fan motor OFF D M L D UL H M L OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF Louver
OPEN OFF OFF CLOSE OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF
42�C
42�C
(ANI2 INPUT VOLTAGE) 0.45V (ANI2 INPUT VOLTAGE) or (ANI2 INPUT VOLTAGE) 0.45V
4 : OFF in the case of Power on start 5 : OFF in the case of Auto restart 6 : ON in the case of Auto restart
12
|
|
|
> |
|
