|
|
|
Who's Online
There currently are 5984 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Everything you need: schematic, circuit explanation, operating/testing instructions. Awesome.
 ;
Correct and accurate service manual for that Siemens (Nordmende) TV. Price is worthwhile as the Manual is fully usable.
;
Just what I needed to repair my CT-F600, clear pdf, easy to tread and navigate
;
Yes, cost is low. And quality of some diagrams is low too.
;
Quick response.
Good quality.
Not large price of documents.
Thanks.
Dzięki.
PG-M15X PG-M15S
AN-M15T
Lamp
The lamp in this projector operates for approximately 1,500 cumulative hours, depending on the usage environment. It is recommended that the lamp be replaced after 1,400 cumulative hours of use or when you notice a significant deterioration of the picture and color quality. The lamp usage time can be checked with the On-screen Display.
CAUTION � Intense light hazard. Do not attempt to look into the aperture and lens while the projector is operating.
� As the usage environment can vary significantly, the projector lamp may not operate for 1,500 hours. � �1,500 hours� above indicates average life span and should be used for reference only. This is different than the warranty period. � For safety, the power will not be turned on from the fourth time when turning on the power without changing the lamp after use for 1,500 hours.
Condition
Problem
Possible Solution � Purchase a replacement lamp unit (lamp cage/module) of the current type BQCPGM15X//1 from your nearest Sharp Authorized Projector Dealer or Service Center. � Replace the lamp. If you wish, you may have the lamp replaced at your nearest Sharp Authorized Projector Dealer or Service Center.
The LAMP REPLACEMENT indicator � Lamp has been used for illuminates red, and �LAMP� will appear in over 1,400 hours. yellow in the lower-left corner of the picture. A significant deterioration of the picture and color quality occurs. The power will automatically turn off and the projector will enter standby mode. �LAMP� will appear in red in the lower-left corner of the picture, and the power will turn off. � Lamp has been used for over 1,500 hours.
1
Turn off the power.
2
Disconnect the power cord.
3
Remove the lamp cage cover.
Press ON/OFF on the projector or POWER on the remote control. Wait until the cooling fan stops.
Unplug the power cord from the AC socket.
Turn over the projector and loosen the user service screws that secure the lamp cage cover. Then lift open the cover in the direction of the arrow.
or
4
Remove the lamp cage.
5
Insert the new lamp cage.
6
Attach the lamp cage cover.
Loosen the securing screws on the lamp cage. Hold the lamp cage by the handle and pull it towards you.
Press the lamp cage firmly into the lamp cage compartment. Fasten the securing screws.
Slide the lamp cage cover in the direction of the arrow. Then tighten the user service screws.
24
 $4.99 AN-M15T SHARP
Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|
