|
Who's Online
There currently are 5766 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
8-17-12 Been using the sight for about 6 months. Fast Downloads and top quality
Manuels !
;
Everything was great, the manual, the response time, the simplicity of the order, and the
Price. The only thing that I could possible say on a negative note would be that the manual I ordered was more for a service tech. There were a lot of schematic diagrams that didn't help me solve the problem. However I would order again and recommend the web sight to others.
;
I'd been looking for this manual for awhile. Exactly what I needed - and at an excellant price. Thanks!
;
very complete. acceptable resolution. details are a little unclear. is a manual note 8.
;
excellent service - fast purchase - easy download - will buy from again
(2) Copy lamp
1 Remove the right and left document guides and remove the table
glass.
How to stretch the mirror base wire (Check the following in advance.) Check the wire winding pulley stopping position. Check the wire winding pulleys (front/rear) have a wire groove in the same position. (Visual checks) If the two wire grooves are much different in their level, loosen two set screws securing the pulleys and align the position of the two wire winding pulleys (front/rear). Tighten the two set screws securing the pulleys.
2 Displace the copy lamp unit to the notched part at the rear of the
upper cabinet.
3 Remove the copy lamp.
1 Hook the mirror base wire holder on the optical base hook. 2 Apply the mirror base B against the mirror base positioning plate.
Pass the front and rear mirror base wires through the outside grooves in the mirror base B pulley.
3 Pass the mirror base wires through the grooves in the paper feed
pulley.
4 Pass the mirror base wires under the mirror base B and wind them
on the winding pulleys. At this time, secure the wire groove of each winding pulley at its upper position. Wind the mirror base wires 9 turns, with the 8th wind settled into the groove.
Note: When reinstalling the copy lamp, use caution not to have the wrong direction.
(Rear)
(Front)
F
R
The 1st wind of the mirror base wires should be 9 � 10 mm away from the pulley groove toward the frame side. The copy lamp should be reinstalled as shown above, so that the copy lamp projection is located close to the R side.
5 Pass the mirror base wires through the groove in the paper exit
pulley.
6 Pass the mirror base wires through the inner groove in the mirror
(3) 2nd and 3rd mirror base unit
1 Remove the right and left document guides and remove the table
glass.
base B pulley.
7 Pass the mirror base wire through the wire guide. 8 Hook the mirror base wire tension spring on the slot in the optical
base.
2 Remove the mirror base wire from the 2nd and 3rd mirror base
unit.
3 Move the 2nd and 3rd mirror base unit to the square hole in the
optical base and twist it to remove.
7 � 12
$4.99 AR5132 SHARP Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft…
|
|
|
> |
|