Well.. I'd searched for this manual and although I found many copies online I was pleased to find your website with a well balanced pricing system and easy to search and follow links. That together with the very quick response time was just what I was looking for.. being a very impatient tech.. ;-) I had the service manual in front of me within a short time.
Bookmarked.. and you can bet I will always come here first for my service & user manuals..
best regards
Ed(Tony) Foley
G7WHK
The service manual when downloaded and printed out was clear and easy to read. I would have liked to have been able to enlarge some details, but this was not possible as the file permissions did not allow this. The service was very good. The time taken from placing my order to downloading the document was only a few minutes.
Text excerpt from page 4 (click to view)
2. Put the copier on the desk.
Hold the four knobs of the copier, fit the four tabs of the copier with the four holes of the desk, and place the copier on the desk.
4. Connect the copier and the desk.
Open the desk front cover. Install the connecting plate large to the connecting plate installing position with the four connecting plate fixing screws to fix the copier and the desk. Then cut off the notch sections (at right and left of the copier) in the connecting plate installing section. Install the connecting plate small to the position shown in the figure below with the connecting plate fixing screws (2 pcs. for each) to fix the copier and the desk.
Notch
Fixing screw
Connecting plate small
Notch
3. Remove the lower tray of the copier.
Remove the lower tray of the copier as shown.
Front cover Connecting plate small Fixing screw
Fixing screw
Connecting plate large
5. Install the lower tray of the copier.
Install the lower tray of the copier as shown.
6. Fix the desk to the floor.
Turn the nut of the adjuster which is in the lower section of the desk with a wrench or nippers in the direction of arrow, and adjust and fix the desk on the floor.