|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Speedy transaction with a quick download. Awesome hassle-free service.
;
very poolite and healpful secure transaction thanks allot
;
- Very good scan quality, PERFECT!
- Sehr gute scan Qualitaet, empfehlenswert!
Wolfgang Sundhaus
 ;
Good site, works ok and you get what you order, no problems experienced, got my manual within a day. A++++
;
Original well scanned manual. Got the job done. Microwave problem found & corrected. For $5 and a new magnitron from ebay, it was a cheap and good the first shot fix. Electrical schematics allowed me to mage sure every thing else was ok before cutting and order for parts. Hard to live without.
5. Connect the connector of the large capacity tray.
Remove the connector cover securing screw for connection of the large capacity tray relay harness connector and remove the connector cover.Then connect the large capacity tray relay harness connector to the connector of the copier and tighten the screw on the connector to secure the connector.
Securing screw
To use the large capacity tray without changing the paper size from the factory default setting:
5 Proceed to step 12 of this installation manual.
At this time, insert the power plug of the copier to an outlet and turn the power switch to the "ON" position.
5 Factory default setting: A4 size
The paper size can be switched only to the B5 size. To use the large capacity tray after changing the paper size from the factory default setting:
Connector cover
7. Remove the stopper from the paper tray.
Pull out gently the paper tray until it stops and remove the stopper securing screw located on the lower part of the right side to remove the stopper. Then pull out again the paper tray until it stops.
Stopper
Screw
Connector
6. Remove the feed table securing screw and securing materials.
Pull out gently the paper tray of the large capacity tray until it stops.Remove the feed table securing screw and 5 securing materials which secure the feed table of the large capacity tray.
Feed table securing screw Securing materials
Securing screw
8. Switch the rear end shaft.
Remove each rear end shaft securing screw (blue) which secures the rear end shaft to the right side in the paper tray and remove the 2 rear end shafts. Then fit the lower part of each removed rear end shaft to the mounting hole of the feed table of the paper tray and secure the upper part to the position with B5 indication using a securing screw (blue).
Rear end shafts
Securing materials
Securing screw (blue)
Securing screw (blue)
Rear end shafts
Feed table
Securing screw (blue)
Push back gently the paper tray to its original position.
Mounting holes Feed table
3�3
|
|
|
> |
|
