SHARP AR-NS2
Service Manual

2. Multi-function machine interface
The multi-function machine interface allows to select the scan mode and the destination profile with the touch key and to start scanning.

3. Packed items
This network scanner kit includes the following items in the package. � CD-ROM (Network Scanner Tool and Sharpdesk, Installer, Sharp TWAIN driver, etc.) � Installation Manual and Instruction Manual (License numbers of 10 user clients of Sharpdesk are specified.) � Document set label (Orientation indication label)

A. Profile base
The user selects the destination profile set by the built-in Web server, and changes the scan setup by using the user interface of the multifunction machine. The user interface also has the operating mechanism to provide easy view of the profile list.

B. Control panel design
This is the overall concept of the digital multi-function machine.
Orientation indication label A Orientation indication label B

Operation flow Press the destination select key. Select the scanner. Set the scan conditions. Press the START key.

4. Installation procedure
To use the scanner expansion kit, the print server card and the memory module (128MB or above) are required. If no memory module is additionally installed, the SDRAM module must be installed. To enable the scanner function, the product key must be obtained. 1) Check the memory capacity of the AR-P11. Print the configuration page by key operations on the operation panel of the machine. Check that the option memory is 128MB or above.

[4] INSTALLATION, SETUP, ADMINISTRATION
The tools, which are supplied to control the network scanner installation, setup, and administration, should be simple and easy in operation, The printer board and NIC are regarded that they have been installed and in operation prior to installation of the network scanner. By installation of the printer board and NIC, the network parameters for the scanner are set.

2) Prepare for enabling the network scanner function. To enable the system configuration, set the mode by key operations on the copier body. � Enter the product key.
#

C

2

6

1

0

Enter the obtained product key with the 10-key to display if on the LCD, and press the OK key. The LCD displays "SCANNER KEY OK." With the above procedures, the product key is set. To reset the system, press the CA key and cancel the setting mode. 3) Paste the label. Paste the label to the rear side of the document glass. If an SPF or RSPF is installed, paste also the label on the SPF or RSPF.

1. Network scanner installation
Check that the printer board and NIC have been installed. The scanner function is allowed by entering the product key in the simulation.

2. System setup by the system administrator or user
A. Network scanner setup
The system administrator sets up some network scan parameters by using a password-protected Web page. These parameters include the FTP server identifying information and parameters and the SMTP server information and parameters.

Orientation indication label A

B. End user setup
The system administrator can make the following optional setups. The end user can install Sharpdesk and the Network Scanner Tool from an install CD or the network drive specified by the system administrator. These procedures may include complete installation of all the proper software applications.

Orientation indication label B

AR-NS2 - 3