|
Who's Online
There currently are 5859 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
I was having a hard time finding the problem with this Mackie 1604 unit. I didn't have a schematic. Went looking on the web and found your site and the price was more then reasonable. Ordered it and within the hour had the manual and within 15 minutes had the unit fixed. Best $4.99 I ever spent. Thank you.
Doug
;
This is a service manual in every sense of the word ( French and German versions of the text are included, as well as English..)
There are explanations of the mechanical and electrical functions, plenty of mechanical drawings, and the needed schematics. The quality of the scanning is excellent - all the component values are clearly legible - and very usefully there are pcb component layouts, so you can find a component on the schematic, and then very quicky pinpoint its physical location on the relevant pcb.
I cannot see how I can give this manual any less than the maximum 5 stars! Great value for money, which will pay for itself immediately. Excellent all round!
;
the manual is great and especially hard to find... thanks for the great service and having a hard to find manuel_
;
Please tell us what you think and share your opinions with others. Be sure to focus your comments on the product. You will receive $2.50 of store credit for Your review.
;
hat alles sehr gut geklappt. Das Servicemaual ist gut zu verwenden. Die Pläne und Schrift
ist klar und leserlich. Außerdem preiswert. Grüße an alle Hifi-Bastler
2) Remove the rear cabinet of the copier.
Remove the seven screws and remove the cabinet. Remove the connector cover.
6) Attach the cushion (one position).
Remove the cover of the double-sided adhesive tape and paste the cushion taking care not to allow it to extend over the plate edges.
�
If a open/close detection is attached, be careful not to break the actuator.
3) Remove the right cabinet.
Remove the five screws.
7) Attach the SPF glass holder cover.
After attaching the SPF glass holding cover, attach the document glass.
4) Remove the document glass holder (left side) and the document glass.
Remove the two screws and carefully remove the document glass holder (left side) and the document glass. Do not separate the glass and holder.
8) Remove the PWB shield plate.
Remove the six screws.
5) Remove the document glass holder cover (right side).
Remove the two screws.
�2�
|
|
|
> |
|