|
Who's Online
There currently are 5853 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
;
Wow very wonderful and clear!!!! I will always trust them
AH-A126E AU-A126E
14-2 TEST 2 (For output of each operation checking) Test mode is for checking output of each operation. Keep pushing both the buttons, "AUX." and "TEST RUN", and supply the power, the system will go to the test 2 mode. In this mode, the output of operation is switched by the "TEST RUN" button in the unit or the "OI" button in the remote controller. Use the "AUX." button to back to step 1. Normal outputs are shown in Table H-5. Table Y-5
Lamps Step 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 Output for outdoor unit OFF ON OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF (Back to step 1) 1 : 7�C : 7�C 2 : �2�C : �2�C 3 : 0.1V : 0.1V Room temp. 42�C (Room temp.) or (Room temp.) Pipe temp. 42�C (Pipe temp.) or (Pipe temp.) ON OFF ON OFF ON OFF RED 1 Flickering ON ON ON ON OFF ON ON ON ON OFF OFF ON ON OFF ON OFF ON ON ON OFF 5 YELLOW 2 ON OFF ON ON 3 ON OFF ON OFF 6 OFF ON OFF ON OFF OFF ON OFF OFF ON ON OFF 4 Indoor Fan motor OFF D M L D UL H M L OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF Louver
OPEN OFF OFF CLOSE OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF OFF
42�C
42�C
(ANI2 INPUT VOLTAGE) 0.45V (ANI2 INPUT VOLTAGE) or (ANI2 INPUT VOLTAGE) 0.45V
4 : OFF in the case of Power on start 5 : OFF in the case of Auto restart 6 : ON in the case of Auto restart
12
|
|
|
> |
|