This is an excellent handbook. We had no information on the appliance until we obtained this and are now able to use the appliance to its full potential. Strongly recommended.
The Owner's manual was very helpful. The WEGA is about 35 years old and needed repair.
Your Website is pretty good und easily to handle.
Thank You
Carl-W. Lohmann
My first manual from Owner-Manuals.com but not the last! I am very satisfied with the easy ordering and promt delivery of a manual I did not find anywhere else.
Text excerpt from page 22 (click to view)
CD-DP900S
Recording to a cassette tape
Before recording: ! When recording important selections, make a preliminary test to ensure that the desired material is properly recorded. ! SHARP is not liable for damage or loss of your recording arising from malfunction of this unit. The volume and sound controls can be adjusted with no effect on the recorded ! signal (Variable Sound Monitor). ! For recording, use only normal tapes. Do not use metal or CrO tapes. Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback only.
Tape Recording
Recording to a cassette tape -
" Recording from a CD (CDs)
You can record 3 CDs continuously.
1 2 3 4 5
Press the ON/STAND-BY button to turn the power on. Load a cassette into the TAPE 2 cassette compartment with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be performed.
Press the CD button and load the desired disc. Press the DISC SKIP button to select the disc to be recorded first. Press the REC PAUSE ( ) button.
Recording will be paused.
6
Press the
/
(TAPE 2
) button to start recording.
! CD playback will start approximately 7 seconds after the tape starts. ! Recording is started from the selected CD. When the playback of the last disc is finished or the end of the tape is reached, the CD and the cassette will stop automatically.
To perform programmed recording:
1 2 3 Programme discs and tracks. (See page 18.) Press the REC PAUSE ( ) button. Press the / (TAPE 2 ) button.
To stop recording:
Press the (CD ) button. The CD and tape will stop.
Notes:
! When the end of the tape is reached whilst recording, the CD player will display the track number which was being played at that time, and stop automatically. If you want to restart recording from the beginning of the interrupted track, turn over the tape, press the REC PAUSE ( ) button and then the / (TAPE 2 ) button. (If tracks have been stored in memory by programming, recording will restart from the first track stored in memory.) ! Whilst recording, OPEN/CLOSE button is deactivated. It is recommended to perform CD recording after closing the disc tray.
