|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
;
Very pleased with the quality of the scan. No complaints whatsoever.
;
I liked the product. I would use their sevices again.
;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
HT-DP2500W
(Continued)
s AM/FM Interval (span)
The International Telecommunication Union (ITU) has established that member countries should maintain either a 10 kHz or a 9 kHz interval between broadcasting frequencies of any AM station. The illustration shows the 9 kHz interval zones (regions 1 and 3), and the 10 kHz interval zone (region 2). This product is not equipped with a span selector. However, it will be adjusted to 9 kHz AM interval (50 kHz FM interval) when shipped from the factory. Before using the unit, be sure to set it for the AM tuning interval (span) used in your area. To check the tuning span currently selected:
1 2
ON/STAND-BY
Set the ON/STAND-BY button on the main unit to ON. Press the TUNER (BAND) button until "FM" or "AM" appears in the display. Press the TUNER (BAND) button to select the AM band.
3
q If "AM 531 kHz" is displayed, it means that the radio has been adjusted for a 9 kHz span. If "AM 530 kHz" is displayed, it means that the radio has been adjusted for a 10 kHz span. TUNER (BAND) ENTER To change from a 9 kHz AM (50 kHz FM) interval to a 10 kHz AM (100 kHz FM) interval:
1
ON/ STAND-BY
Press the ON/STAND-BY button on the remote control to enter the stand-by mode. Hold down the TUNER (BAND) button and the ENTER button for at least 4 seconds. Release the buttons when "AM SP 10 kHz" and "FM SP 100 kHz" are displayed alternately.
2
To return to a 9 kHz AM (50 kHz FM) interval:
1 2
[9 kHz � 10 kHz]
Press the ON/STAND-BY button on the remote control to enter the stand-by mode. Hold down the TUNER (BAND) button and the ENTER button for at least 4 seconds. Release the buttons when "AM SP 9 kHz" and "FM SP 50 kHz" are displayed alternately.
(4 seconds)
Caution: q When the unit is left for a few hours after the span has been switched and AC power lead disconnected, it will be automatically returned to a 9 kHz span. If this happens, set the span again. q When the span is switched, any stations that are memorised will be cancelled.
[10 kHz � 9 kHz]
(4 seconds)
�5�
|
|
|
> |
|