There are currently no product reviews.
Great site, I always find all the manuals I need and i can't find anywhere else. PDF for the Sony PCM 3348 is complete and scan is good quality. Thank you!
It was a complete manual as stated. Very good source for older product manuals. Thanks
Scan quality is very good. Price is very reasonable. If you're looking to purchase a copy of this manual, this is the one to get.
Perfect for my use.Could have better pictures,but otherwise perfect ;)
This is one of four manuals I have downloaded recently.
Purchase was very straight forward and the authorising email arrived in about 4 hours.
The quality of the scan is good. Print is clear and square to the page edges.
Use 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar). Batteries are not included.
Turning the power on
! Test of the remote control
Check the remote control operation after making all the connections (see pages 14 17). Point the remote control directly at the remote sensor on the unit.
1 Open the battery cover. 2 Insert the batteries according to the direction indicated in the battery compartment. 3 Close the cover.
When inserting or removing the batteries, push them towards the nals. battery termi-
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your system.
0.2 m - 6 m (8" - 20')
SUBTITLE LANGUAGE DISPLAY
Precautions for battery use:
" Replace all old batteries with new ones at the same time. " Do not mix old and new batteries. " Remove the batteries if the unit is not to be used for long periods of time. This will prevent potential damage due to battery leakage.
! To turn the power on
" Do not use rechargeable batteries (nickel-cadmium battery, etc.). " Incorrect installation may cause the unit to malfunction.
Preparation for Use
92LCN500U0270 Battery installation / Turning the power on -
SHARP 92LCN500U0270 (UK)
Notes concerning use:
" Replace the batteries if the operating distance is reduced or if the operation becomes erratic. " Periodically clean the transmitter on the remote control and the sensor on the unit with a soft cloth. " Exposing the sensor on the unit to strong light may interfere with operation. Change the lighting or the direction of the unit. " Keep the remote control away from moisture, heat, shock, and vibrations.
Power stand-by indicator
Press the ON/STAND-BY button.
If the power does not turn on, check the AC power lead is plugged in properly.
To set the unit to the stand-by mode:
Press the ON/STAND-BY button again. The power stand-by indicator lights up.