|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very good quality pdf file, no missing pages and all words and schematics clearly readable. Whole manual is present featuring different languages.
;
Very,very good manual.It was very explicit and readble.It was helpfull.Thanks.
;
The service manual is scanned, but high quality, high resolution. The smallest texts on schematics diagram is readable. Super! Thank you!
;
I am satisfied with the service. And if need another manual, i will definitely buy from this site. Keep up the good work.
;
have download a number of manuals todate , most are excellant, one or two sometimes a little difficult to read but a least avaialable, great site .
Brad.
Setting the Roller Cleaner
1 Open the top cover while keeping the front cover open.
NOTE: Press both sides until the top cover clicks.
4 Remove the charger cleaner from the rear cover.
2 Remove the roller cleaner from the plastic bag and set it on the
fusing unit.
5 Insert the charger cleaner into the main charger and clean the
metal plate by sliding the cleaner as shown below.
3. Close the top cover until it clicks. 4. Close the front cover until it clicks. NOTE: � Do not pull out the cleaner halfway on the metal plate. Be sure to end at either the left or the right end on the plate.
4. Cleaning
(1) Cleaning the Main Charger
1 Turn off the power. 2 Open the front cover.
6 Replace the charger cleaner on the rear cover. 7 Close the photoconductor cartridge until it clicks. 8 Close the front cover. 9 Turn on the power.
�
Push the cover release lever ( 1 ) and open the cover by holding both sides ( 2 ).
2
(2) To clean the transfer charger:
1. Turn off the power. 2. Open the front cover.
1
�
Push the cover release lever ( 1 ) and open the cover by holding both sides ( 2 ).
2
3 Position the photoconductor cartridge vertically.
1
�
Insert your hand into the opening between the face down tray and the photoconductor cartridge. Push the lever at the back of the photoconductor cartridge with your fingers and then rotate the cartridge until the cartridge is positioned vertically. The main charger exists near the drum. 3. Remove the charger cleaner from the rear cover.
Main Charger
� 10 �
$4.99 JX9680 SHARP Owner's Manual Complete owner's manual in digital format. The manual will be available for download as PDF file aft… $4.99 JX-9680 SHARP Parts Catalog Parts Catalog only. It's available in PDF format. Useful, if Your equipment is broken and You need t…
|
|
|
> |
|