|
|
|
Who's Online
There currently are 5949 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I have this hi-fi system for a long time and I need to repair some things. Founding this manual will be very helpfull :)
 ;
It is pretty good. The schematics were covered all components, the manual also provide the parts list . It's useful for the trouble shooting.
;
Very fast service, best quality of the service manual and the schematics
;
This service manual of the old video cassette recorder VT-LC50EM is very good readable even the tiniest numbers (i.e. IC-pins). The circuits are very clear. Many details of the schematic are very good described but in GERMAN language. Many schematic details - but complete at all. Common background information of several details are enclosed and physical knowledge of the TFT liquid crystal display for example. The manual lacks PCB drawings. If you understand german I would recommend this manual for you.
;
Hi, this is a very clear manual, nice copy, not quite up to the standard of the very best available but better than many others. I think the price was especially fair for a hard to find manual and I would certainly use this manual seller again. Recommended.
LC-13B2E
ADJUSTING PROCEDURE OF EACH SECTION
[1] Entering the MAIN side adjustment process mode
There are three methods below. 1) Press the �Adjustment process key� on the remote control after turning on the power. 2) Pressing both the MENU key and the TV/VIDEO key on the main body, turn on the power. Then, press the volume DOWN key and the tuning DOWN key at the same time. 3) Turn on the power with falling either KEY4 (pin (81) of microprocessor) or KEY5 (pin (82) of microprocessor) to �L�. [Note] For the method 3), the ROM is initialized at the same time. Therefore, 3) must be executed, if IC2004 or IC2001 is changed. For 1) or 2), the main body only enters the MAIN side adjustment process.
[2] Entering the TUNER side adjustment process mode
4) Entering the TUNER side adjustment process MENU key on the main body � Cursor UP key (remote control) � Select the position shown in the figure below and press the M key (remote control) within 1 second. � Enters the adjustment process.
Direct control at TV
Black level Contrast Colour
: select
M: Back E: End
[3] Adjustment
MAIN side adjustment (Press the �M� key to move the cursor and press the volume UP/DOWN key to make an adjustment.) � Power supply voltage adjustment (+B 5V) � Model setting � Inch size setting � COMMON BIAS adjustment of LCD module � CUTOFF adjustment TUNER side adjustment (Press the tuning UP/DOWN key to move the cursor and press the volume UP/DOWN key to make an adjustment.) � Horizontal size adjustment (LCD adjustments) � Video adjustment (other adjustments) Y delay Subcontrast Subcolour Subbrightness Tint offset AGC gain start The TUNER side adjustment is possible. However, it is recommended to replace EAROM (I2).
9
|
|
|
> |
|
