|
|
|
Who's Online
There currently are 5878 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I liked the product. I would use their sevices again.
 ;
I Recently purchased yet another Service Manual from Owner-Manuals.com, this time for a Sony EVS700ES/UB Videocassette Recorder. The Manual was available for upload within two hours and is an Extremely Good copy, as some of this I was able to enlarge to get even better detail.
Once Again, Very happy with the result!
;
A good and useful manual. With these, We was abled to isolate and pin point the component that was causing the problem. The total time spent in troubleshooting is very much reduced.
;
The quality of the manual is top. The transfer worked perfect and fast.
No problems at all. Recommendable
;
Very good service for get any documentation. Fast and perfect quality.
LC-15A2E
ADJUSTING PROCEDURE OF EACH SECTION
[1] Entering the MAIN side adjustment process mode
There are three methods below. 1) Press the �Adjustment process key� on the remote control after turning on the power. 2) Pressing both the MENU key and the TV/VIDEO key on the main body, turn on the power. Then, press the volume DOWN key and the tuning UP key at the same time. 3) Turn on the power with falling either KEY4 (pin 81 of microcomputer) or KEY5 (pin 82 of microcomputer) to �L�. [Note] For the method 3), the ROM is initialized at the same time. Therefore, 3) must be executed if IC2004 or IC2001 is changed. For 1) or 2), the main body only enters the MAIN side adjustment process.
[2] Entering the TUNER side adjustment process mode
4) Entering the TUNER side adjustment process MENU key on the main body � Tuning UP key (remote control) � Select the position shown in the figure below and press the M key (remote control) within 1 second. � Enters the adjustment process.
Direct control at TV
Brightness Contrast Colour
: select
M: Back E: End
[3] Adjustment
MAIN side adjustment (Press the �M� key to move the cursor and press the volume UP/DOWN key to make an adjustment.) � Power supply voltage adjustment (+B 5V) � Model setting � Inch size setting � COMMON BIAS adjustment of LCD module � CUTOFF adjustment TUNER side adjustment (Press the tuning UP/DOWN key to move the cursor and press the volume UP/DOWN key to make an adjustment.) � Horizontal size adjustment (LCD adjustments) � Video adjustment (other adjustments) Y delay Subcontrast Subcolour Subbrightness Tint offset AGC gain start The TUNER side adjustment is possible. However, it is recommended to replace EAROM (I2).
8
|
|
|
> |
|
