|
Who's Online
There currently are 6043 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Excellent service and prompt delivery. But it's not a manual - only 4 pages wiring diagrams.
Thanks.
;
The manual I purchased was exactly what I needed to repair my Toshica television. The manual contained schematics and troubleshooting information that was very helpful.
;
Il download del Service Manual JVC HR 4100 non é stato eseguito
;
The Service Manual was just as expected, complete with schematics and I was able to download it in less than an hour after I ordered it. The only problem with these is that the schematics are hard to read due to the small font. I could remedy this by printing them on a larger printer.
;
Very fast, clear and usefull site !
Also this Service Manual are very well maked and with a very good definition !
Very fast download speed !
Recomended Seller !
CHAPTER 4. TROUBLESHOOTING
No power supply
Does LED turns on in green when power switch is turned on? Yes
No
No output +5V, 12V from power supply unit.
Yes
Replace power supply unit.
LED turns on in red? No
Yes
* Check LED for breakage. * Check key cable for disconnection. Yes Replace any unit (main PWB, SW PWB, cable) which shows any defect, with a new one.
No Backlight turns ON? Yes LED turns on in orange? No Yes
Check whether the unit is in power save mode (synchronizing signal is not input.). 1) PC is turned off? 2) RGB cable is disconnected? 3) Synchronizing signal is output from RGB cable?
Check for RGB cable input signal. Normal Defective
Check each pin terminal of P3. Normal
No
Synchronizing signal is input to main PWB? Yes No Replace RGB cable with a new one.
A
Replace RGB cable.
* Check inverter PWB unit. Note: Use caution when checking output side because it has a high voltage. Normal Defective
Check power input system. 1) Power supply PWB * Normal? * Connected properly? 2) Blown out fuse (F1)? 3) Check +5VX, 3.3VX, 3.3VA, VDD, VD and VLCD are output? 4) LED * Check LED for breakage. * Check the path between P5 and U6. * Check the cable for disconnection. Yes
Replace inverter PWB unit with a new one.
Replace LCD module lamp with a new one.
Replace any defective unit. [ 1) Power supply PWB, 2) Main PWB, 3) Switch PWB ] with a new one.
LL-T15S3
TROUBLESHOOTING
4�1
|
|
|
> |
|