|
Who's Online
There currently are 5716 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Very,very good manual.It was very explicit and readble.It was helpfull.Thanks.
;
The service manual is scanned, but high quality, high resolution. The smallest texts on schematics diagram is readable. Super! Thank you!
;
I am satisfied with the service. And if need another manual, i will definitely buy from this site. Keep up the good work.
;
have download a number of manuals todate , most are excellant, one or two sometimes a little difficult to read but a least avaialable, great site .
Brad.
;
Excellent had everything I wanted, very happy with purchase
MD-DR470H/MD-DR480H
� Abnormal display
Is a waveform found in pins 8 to 10 of CN451 ? Is pin 2 (VCC) and pin 6 (GND) of CN451 normal ? No Check between IC401 and CN451. Check around IC401. Is a waveform found in pins 29 to 31 of IC401 ? Yes Yes No
Check the pattern and soldering of SW flexible PWB and LCD flexible PWB. If no problem is found, replace the LCD.
� Audio playback circuit
If playback time is counted but no sound is heard during continuous playback. Is an audio waveform found in pins 1 (TP721), 2 (TP722), 3 (TP723) and 4 (TP724) of J703 ? No Is there a pulse where duty varies in pins 2 and 5 of Q751, Q752, Q761 and Q762 ? No Is a pulse waveform found in pins 1, 4, 9 and 12 of IC751 and pins 1, 4, 9 and 12 of IC761 ? Are pins 2, 5, 10 and 13 of IC751 H ? Check pins 68, 69, 71 and 72 of IC201 and pin 19 of IC401. If the voltage of pin 6 of Q751 and Q752 and pin 3 of Q761 and Q762 is below 2 V when setting VOLUME to MAX, check the power supply circuit of IC813 and IC821. Check soldering of J703, the remote control and the earphones. Yes
Yes
No
� The spindle motor does not rotate.
Does a waveform appear in pins 26 and 27 of IC201 after ending the test mode AUTO2 ? Yes
No
Check the periphery of IC201.
Is a waveform found in pins 60 to 64 of IC601 ? Yes If there is no defect in soldering of IC601 and insertion of the flexible PWB, replace the spindle motor.
No
Check the periphery of IC601.
� 42 �
|
|
|
> |
|