|
Who's Online
There currently are 5546 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Some of the pictures in this manual are a bit irritating. I had to dissassemble the unit and some of the screws have different threads, which is not mentioned in this manual. Also some of the drawings of the boards look different than the actual boards.
After all, the manual was very useful. I was able to recalibrate the capstan drive and it is working fine again.
;
This manual is very good. 303 pages scanned in a very high resolution. My camera has bad, leaking capacitors which all of the V5000 models are suffering from these days.
There is a huge part list with all capacitors, transistors etc. in this manual which helped me a lot. Otherwise I would not have been able to buy replacement parts.
The dissassembly guide is very enormous and detailed. Unlike on the Panasonic MS1 manual I downloaded here it actually looks like the real parts look. And the screws are labeled correctly, so you shouldn't have any left after the repair. ;)
;
has all the schematics you could need,and very well laid out format also has all part numbers along with an exploded view which is helpful
;
Very nice to have! Now it is no problem to understand how it is put together.
Helps me a lot.
;
good scans, all is clear. all pages in order. recommended
MD-MT15/15C/15H/15W/161E/18H
NOTES ON SCHEMATIC DIAGRAM
� Resistor: To differentiate the units of resistors, such symbol as K and M are used: the symbol K means 1000 ohm and the symbol M means 1000 kohm and the resistor without any symbol is ohm-type resistor. Besides, the one with �Fusible� is a fuse type. � Capacitor: To indicate the unit of capacitor, a symbol P is used: this symbol P means micro-micro-farad and the unit of the capacitor without such a symbol is microfarad. As to electrolytic capacitor, the expression �capacitance/withstand voltage� is used. (CH), (TH), (RH), (UJ): Temperature compensation (ML): Mylar type � The indicated voltage in each section is the one measured by Digital Multimeter between such a section and the chassis with no signal given. � Parts marked with � �( ) are important for maintaining the safety of the set. Be sure to replace these parts with specified ones for maintaining the safety and performance of the set.
REF. NO SW401 SW402 SW403 SW902 EJECT HOLD DISC LID OPEN DISC PROTECT DESCRIPTION POSITION OFF�ON OFF�ON OFF�ON OFF�ON
B (G) (3) E (S) 1
TOP VIEW TOP VIEW 2SA17457 2SC4213 B RN1103
C (D) (2)
TOP VIEW
1SS361
SB10015 C
TOP VIEW
TOP VIEW
TOP VIEW
1SS372
1SS360
SBE803 2SA1873 GR
Figure 11 TYPES OF TRANSISTOR AND DIODE
� 11 �
|
|
|
> |
|