|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
very good manual with clear electrical schemes. Very helpful to find wat was wrong inside my microwave.
 ;
Hi, thankyou for providing the Nordmende Globetrotter original manufacturer's repair manual. Quality is very good and sharp - the PDF file was comfortably small to download. The only question is: why did it take so long to become ready for download?? Many thanks anyway, I fixed the fault in the radio thanks to the circuit.
regards: Nick
;
This was super service.Ordered this manual and was reading the download an hour later
;
as always, rapid and efficient, very good and clear prints
details clearly visible keep going this way!!!!!!
;
I expect a wonderful result as alaways!!!!!!
Usually is much faster....
7)
Staple motor (FFSM) drive circuit
Staple motor (FFSM)
This circuit controls rotation/stop and the rotating direction of the staple motor (FFSM), and is composed of the CPU (IC10) and the FET (Q10, 11, 12, 13). The DC motor is controlled with the staple motor (FFSM) drive normal rotation signal, the reverse rotation signal, and the brake signal outputted from the CPU (IC10-5, 8, 9pin). To protect the motor and the mechanism, the current limit circuit is provided, which supplies the motor drive OFF signal when the current flowing through the detection resistors R78 and R79 exceeds 3.8A, restricting the current not to exceed 3.8A. 8) Tray motor (FTLM) drive circuit 9) Fan (FFAN) drive circuit
Tray motor (FTLM)
Fan (FFAN)
This circuit controls the tray motor (FTLM) rotation, stop, and rotating direction, and is composed of the CPU (IC10) and the DC motor driver IC (IC19). The CPU (IC10-69, 70pin) outputs the tray motor (FTLM) drive normal rotation signal, the reverse rotation signal, and the brake signal to control the DC motor. In addition, the current limiting circuit is formed with R129, R130, R131, and R132 for the current flowing through the motor not to exceed 0.65A.
This circuit controls the fan (FFAN) rotation, stop, and rotating direction, and is composed of the CPU (IC10) and the digital transistors (Q14, Q18). The DA converter (IC11-13pin) outputs the fan (FFAN) drive signal to drive the motor. The fan lock signal is inputted through the noise filter of R168 and C130 to the CPU (IC10-20pin) by the open drain output of the fan built-in circuit. The logic of the signal inputted to the CPU is H when locked.
MX-FNX1/MX-PNX1 ELECTRICAL SECTION 10 � 6
|
|
|
> |
|
