|
Who's Online
There currently are 5778 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Finally, i found one website, where i can download this service manual , and fix my hifi. The service manual is very good, and easy to download and to print.
;
Complete and very useful. Could have benefited from a little higher resolution on the schematic and layout diagrams for improved legibility.
;
Great Service Manual, Very Complete, as advertised, Perfect, Thanks!
;
Good quality service manual.It has helped me to fix my FV1800,particularly for replacing the dial cord.The scheme is on A3 format and very readable.Thank.Olivier.
;
This manual is complete and very readable.It was a great help for my two ICF5800L.The first one had the dial cord broken,and without the service manual it is impossible to replace it.Thank.Olivier.
SD-CX1H
� The triangular wave for focus servo does not appear.
Is +3.3V applied to pin 6 on IC3 ? No Yes Does the triangular wave appear at pin 33 on IC3 ? <Refer to the waveform diagrams on page 73.> Yes Does the triangular wave appear at pin13 of IC1 ? <The same waveform as above> Yes Does the saw tooth wave appear between pins 3 and 4 of IC1 ? <Refer to the waveform diagrams on page 73.> Yes Does the saw tooth wave appear between pins 3 and 4 of CNS2 ? <The same waveform as above> Yes The PWB pattern has been cut. No The connection of CNS2 is poor or the optical pickup is defective. Check the parts around IC1 and the power supply line. IF OK, IC1 is defective. No The connection of signal lines between pin 33 on IC3 and pin 13 on IC1 is poor. No Check the parts around pin 33 on IC3. If OK, IC3 is defective. The +3.3V line of IC3 is defective.
No
� The disc motor CLV servo is defective.
Does the disc motor rotate in the CD test mode 3 ? Yes
No
Is the voltage applied between pins 27 and 28 of IC1 for about 0.3-1.5 seconds when switching from the CD test mode 2 to 3 ?
Yes
The disc motor is defective or wires have broken.
0.3~1.5 seconds
No
Does the disc motor rotate too rapidly or slowly ? Yes
Is the pin 41 on IC3 in the high state for 0.3-1.5 seconds and does it pulse when switching from the CD test mode 2 to 3 ? <Refer to the waveform diagrams on page 72.> Yes
No
IC3 is defective.
5V 0.3~1.5 seconds
C3 is defective or wires have broken. Does the eye pattern appear at pin 19 on IC2 ? <Refer to the waveform diagrams on page 72.> (It is OK even if the waveform is not clear.) Yes (Vp-p 1.2V waveform) Recheck whether the optical pickup objective is dirty. If it is dirty, clean it. Check the connection between pin 19 on IC2 and pin 24 on IC3. If OK, the optical pickup is defective.
No
Is the eye pattern Vp-p 1.2V inputted to the pin 24 on IC3 ? Yes
No
Check the PWB pattern and C33.
IC3 is defective. (After checking the parts around it, replace it.)
� 77 �
|
|
|
> |
|