SHARP SJ-2025-WH
Service Manual

SJ-2025

4. DEFROST HEATER (1) Taking-out Evaporator 1. Take out F-louver ass'y (Fig. A-22).

(2) Replacement of Def. heater ass'y. 1. Disconnect the lead wires inserted in the rib of center partition (Fig. A-25 : 8 pcs.).

Evaporator

Food liner convex part

Tape
Fig. A-22 2. As shown in Fig. A-23, pull the upper part of Evaporator toward you, pull it diagonally so that the pipe of Evaporator does not contact the convex part of food liner.
Food liner convex part

Tape Vinyl tape Def. heater L ass'y

Evaporator

Fig. A-25
Pipe

2. Raise the protrusion part of Drain support AL (Fig. A-26). Then remove Heater cover.
Protrusion part of Drain support (2 pcs.)

Fig. A-23 3. As shown in Fig. A-24, bend the removed Evaporator horizontally so that Defrost heater can be replaced easily. NOTE: When pulling Evaporator and bending the pipes, pay attention so as not to break and deform the pipes. Still, take care not to hurt yourself by fin of Evaporator.

Def. heater ass�y Heater cover Removing direction Mounting direction

Fig. A-26 3. Open Def. heater fixed part of Drain support (Fig. A-27) to the right and left, then remove Def. heater ass'y.
Evaporator

Removing direction Mounting direction

Fig. A-24
Screw Screw

Drain support Def. heater ass�y
Fig. A-27 19