|
|
|
Who's Online
There currently are 5916 guests and
1 member online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Very good manual. Plenty of service information including alignment instructions. Clear circuit diagram. Excellent, thank you.
 ;
Good morning, the service manual you sent me was perfect.
Your service and answering are excellent.
I recomend this service.
Best regards.
;
I had been looking everywhere for a proper service manual for this VCR. Everywhere else that has this available for download has a very light version. This is the full service manual with all aspects that would interest anyone looking for the service manual for the AIWA HV-MX100 Worldwide VHS VCR. Great quality (as always). A winner hands down. Best Quality.
;
Top quality manual. Covers all aspects you'd expect in a top quality service manual for this Panasonic VHS VCR. The manual resolution is high. Another top quality manual from the only site worth downloading manuals from! If you're looking for a manual for the PV-9662 VHS VCR, this is the one you'll want to get!
;
complete part-lists and pcb layout, schematic diagram is good enlargable,
PC-UM10M
8. SHORT BATTERY LIFE
First of all, explain that the battery life varies depending on the use environment and the operating conditions. 1) According to �BATTERY VOLTAGE ADJUSTMENT PROCEDURE� on the Service Manual, check the set values. (If necessary, make setting again. 2) Execute �CURRENT COMSUMPTION CHECK� on the Service Manual to check the current value. 3) Replace the battery pack.
9. THE CF CARD (SD CARD) IS NOT RECOGNIZED. / WHEN THE CF CARD IS INSERTED, NO OPERATION IS PERFORMED
First of all, check for deformation of the connector terminal of each card. 1) Check CF CD and SD CD on the right lower side of the diag menu. All should be "H." 2) Insert the CF card and the SD card, and check again. All should be "L."
NG(Remains at "H")
The card is not recognized. When the CF card : Check "CD" pin of the connector and is not recognized check CCD** of BR403 and IC401. When the SD card : Check soldering of the terminals outside is not recognized of the connector of CN1002 of the sub PWB. Check IC901 and BR906. TOP This terminal
3) When the CF card is inserted, no operation is performed.
Check with the OS. When the "WAIT" signal of the card is at "LOW", no operation is performed. (Wait is applied to the operation.) Check IC401 and BR402. (Check that soldering is properly made and that the resistors are not broken.)
SL-5500 TROUBLE SHOOTING
� 62 �
|
|
|
> |
|
