|
Who's Online
There currently are 5640 guests online.
|
Categories
|
Information
|
Featured Product
|
|
|
|
|
There are currently no product reviews.
;
Providing the manual works fine, quickly and without any problems for an acceptable price. After printing the service manual it took me only a short time to repair my carradio from Clarion. Thank You! Greetings from Heiko
;
I was searching a way to modify the original phono-in entry (for connection of vynil disc player, with RIAA equalization) to a line-in entry (for connection of modern analog entries, eg. ipod, mp3player).
This service manual gave me the correct hints.
It contains very useful infos for repairing and modifing the hi-fi, such as disassembling instructions, block diagrams, schematic diagrams, PCB prints, replacement parts list.
Very good!
;
Great Job!!! clear and efficient as always!!
it is really nice to have peple that are doing such a good work!!!!!
;
I must admit, I was very skeptical... $4.99 for a 74 page service manual. I've seen some very poorly scanned manuals on the Internet, but this one is VERY good quality! Even when zooming into 500%. Great Deal!
;
Very good detail, Quick service response. A useful service manual with all details. I recomend this service.
FLOW CHART NO.10 FLOW CHART NO.9
The cassette tape fails to eject. No power is turned on.
See FLOW CHART NO.11.
pin(76) of IC701 change from "L" to
Does the capstan motor start when NO Check IC701. the EJECT button is pressed? "H" level?
NO Does power control(H) signal at
YES YES
NO take-up turn when disk reel drive unit. Does base of Q961 change from NO Check IC701 and all the way up thru YES
the capstan motor is running? about 0V 5.7V? to Q961.
way up thru to IC701.
Q961?
YES
Check take-up reel sensor and all the NO Is 5V sent out the emitter of Are pulses applied at pin(2) of IC701 Check Q961 and the AT 5V line. when the take-up reel disk is turning?
YES
Does pin(10) of P701 go from 2.5V NO to 0.8V when reel pules has been
Check peripheral circuits for poor
Check pin(72) of IC701. soldering.
input.
YES
Does the motor run? Replace loading motor. FLOW CHART NO.11
NO
YES The capstan motor fails to run.
Replace cassette cam, gear, etc.
39
Is the voltage more than about 2.6V NO DC given out pin(24) of IC701. pin(3) of P701.
NO
Check IC701.
YES NO Is the supply voltage of 5V feed to
Check PC 5V line.
YES
Check between pin(9) of P701 and Is the voltage more than 2.6V DC all the way up thru to pin(24) of sent in pin(9) of P701. IC701.
YES
Check between the pin(71) of IC701 Is the voltage at pin(5) of P701 NO and all the way up thru to pin(5) of 3.5V? P701.
YES NO Check motor-VCC line and motor
Is the supply voltage of 23V feed to voltage selector circuit. pin(2) of P701. YES
Replace capstan motor.
VC-A433M/H833M
|
|
|
> |
|