Using the Hand Strap and the Lens Cap 1
Open the hand strap flap (Q) and grip strap (W).
Hand strap flap Grip strap
Notes: â¢ Always replace the lens cap on the lens when the VIEWCAM is not in use. â¢ Attach the lens cap to the hand strap so it will not get in the way during recording.
Attaching the Shoulder Strap 1 2
Pass your hand through the hand strap and put your thumb close to the Power Zoom control. Then pull the grip strap tight until it fits snugly, seal the VelcroÂ® closures (Q), and close the hand strap flap (W). Hold one end of the strap and thread it through the loop on the left side of the LCD screen. Loosen the strap in the buckle, then feed the end of the strap through the buckle, as shown. Draw the strap in the direction of the arrow to secure. Use the same procedure to attach the other end of the strap to the loop on the lens side.
Caution: â¢ Do not swing the VIEWCAM by the hand strap.
LCD screen side
Attaching and Removing the Lens Cap
When attaching or removing the lens cap, press both tabs on the sides of the cap.
Press both tabs.