|
|
|
Who's Online
There currently are 5683 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Readable text and good copy. Very much needed if you wish to do some repairs on this fine old unit.
;
Fint forløb med levering af manualen. Kvaliteten af skanningen betegnes som middel
 ;
I found the manual to be clear concise and complete. It was of immense assistance when removing the unit as the unit was over 22 years old and the wiring diagram was unobtainable from the manufacturer. The exploded drawings were clear as were the instructions and labels.
;
I will highly recommend this seller. They are honest, accurate, fast and responsible.
;
This manual was very good & was very helpful with repairs.
Always great & fast service from Owner's manual.
VL-PD3AS/AH/AE
3. DISASSEMBLY OF THE SET
Note: Before removing the cabinet, turn off the power supply, and ascertain that the battery have been removed. 1. 5.
V/F section
(D) (D) (D) (C) (D)
(G)
· Remove the screws ((D)XiPSF17P03000)(4pcs.) of the bottom · Up the section of V/F, and remove the screw ((D)XiPSF17P03000) cover and them. (1pc.). · Remove the screws ((D)XiPSF17P03000)(2pcs.) and ((C) 2. XiPSF1704000)(1pc.). · Remove the screw ((G)XiPSN17P03000)(1pc.) and battery cover.
(F)
6.
(F)
(D)
(B) (F) (R)
· Remove the screws ((F)XiPSN17P04000)(3pcs.), ((B)LXHZ0050TAFN)(1pc.) of the front cover and the DV terminal's screw ((R)XiPSN16P05000)(1pc.).
3.
Remove the claw
(D)
(D)
(D)
· Remove the screw ((D)XiPSF17P03000)(1pc.) of topside and open the cassette compartment door, remove the screws ((D)XiPSF17P03000) (3pcs.) of both sides and center screws. Remove the Remote control receiver unit connector, the Zoom FPC, the EJECT switch connector, the H/A connector, and the cabinet A.
(B)
7.
(D)
· Open the LCD panel, remove the screws ((B)LX-HZ0050TAFN) (2pcs.), the claws what is connected the cabinet A and remove the front cover. Be careful so that not damage the lead wires of microphone when it removes the front cover.
(H)
4.
(G) (G)
· Remove the screw ((D)XiPSF17P03000)(1pc.) topside of cabinet B and the screws ((H)XiPSN17P02000)(1pc.) of side surface and ((G) XiPSN17P03000)(1pc.) of rear surface.
Microphone connector
(Note.) In case of disassemble or assemble the section of V/F, do the work with great care that there are never taint or intermix of dust.
· Slide the section of V/F, and remove the plate of topside, the screws ((G)XiPSN17P03000)(2pcs.), and remove the top cover what is slided toward V/F slide.
4
|
|
|
> |
|
