|
|
|
Who's Online
There currently are 5830 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The owner's manual/operating instructions that I purchased was the original factory document and it was in at least three and maybe more languages. I no longer have it because I sold the tape recorder and included the owner's manual/operating instructions and a service/repair manual that I bought on ebay for the new owner.
;
This manual is very useful. Because pioneer sx-q180 is unhandy to use without manual.
;
Manual was destroyed and this purchase made it possible to recover my manual . It was easy to down load and smooth to use thanks .
 ;
Turns out this was not the manual i was looking for. The concertmate 670 keyboard i have is a "Realistic" model made for Radio Shack and none of the diagrams on the owners manual i received matches up. HOWEVER, I must say the service Owners Manual provides was fast and efficient by being available online. The manual was in good readable condition and easily downloaded.
;
Great price, Quick delivery, the document was very usefull A+++++++++++++++
Preparation
Adjusting the Hand Strap 1
Open the hand strap flap (1) and the grip strap (2).
When attaching or removing the lens cap, press both tabs on the top and bottom of the cap.
Tabs
Hook
Preparation
When recording, hang the hook of the lens cap on the hand strap so that the cap will not get in the way.
2
Loosen the grip strap, pass your right hand through the loop, and put your thumb on the REC START/STOP button. Then, pull the grip strap tight until it fits snugly.
Note: � Always replace the lens cap on the lens when the camcorder is not in use.
Attaching the Shoulder Strap 1 2 3
Remove the battery pack. Hold one end of the strap and thread it through the loop on the left side of the power source mounting surface. Loosen the strap in the buckle, then feed the end of the strap through the buckle, as shown. Draw the strap in the direction of the arrow to secure. To attach the other end of the strap to the loop on the left side of the hand strap, open the hand strap flap, perform the same procedure, and then attach the battery pack.
2 5
Loop Loop
REC START/STOP button
3
Seal the velcro fasteners of the grip strap and the hand strap flap.
4
Caution: � Do not swing the camcorder by the hand strap.
5�7
Using the Lens Cap
Attach the strap of the lens cap to the hand strap as shown below.
3
6
Buckle
Buckle
4
7
15
|
|
|
> |
|
