|
|
|
Who's Online
There currently are 6028 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
Superb manual. Exactly what I ordered and made available in a very timely manner.
 ;
very fast detailed and accurate hope to do business again
;
This was precisely what I was looking for. Complete and good quality!
;
This is the ONLY copy of this manual I could find for a realistic price. Even Panasonic could not provide me with one.
The PDF is a very good copy and it helped me diagnose and find the fault with the unit I have.
;
Very complete and well reading drawings. Documentation is essential for successful repairs.Good documentation, with all that is necessary. This manual was what I was waiting with all the information necessary for the repairing I need it for. You must buy it if you want to do repairs or simply understand how it works.
XL-MP110H/MP110E
2. CD MECHANISM SECTION
Perform steps 1 to 3, 14 of the disassembly method to remove the CD mechanism.(see page 3-3,3-4)
Stop Washer (A3) x1 Optical Pickup CD Mechanism (A1) x2 ø2.6 x5mm
2.1. How to remove the Optical Pickup (See Fig. 1)
1. Remove the screws (A1) x 2 pcs and shaft (A2) x 1 pc. 2. Remove the stop washer (A3) x 1 pc and gear (A4) x 1 pc. 3. Remove the optical pickup. NOTE: After pulling out the optical pickup connector, wrap the tip of it with conductive aluminium foil or the like to protect the optical pickup from the static electricity.
Shaft (A2) x1 Gear (A4) x1
2.2. How to remove CD Disc (See Fig. 2~6)
1. When CD is at play position, rotate reduction gear C clock-wise as shown in Figure 2 until disk tray is at �STOCK� position, then rotate the gear further to eject the disk tray (Figure 6) so that CD can be removed from the tray. 2. In another case, if CD mechanism is at tray No. 1 play position and to remove CD located in tray No. 3, the procedure is as follows: If the gear up down board is located at tray No. 1 position, then rotate Reduction gear C clock-wise until Disc tray is at �STOCK� position. Rotate reduction gear D clock-wise (Figure 3) to move the CD mechanism to tray No. 3 position. This is confirmed by checking the gear up down board position base on the marking as indicated on the main chassis as shown in Figure 4. � Usually changer is covered with top plate. As for reference purpose, we exclude the top plate for easy viewing. (Figure 5,6)
Figure 1
Reduction gear C
Front
Rear
Figure 2
Disc Tray Guide Tray CD Disc
Reduction gear D
Up
CD At 'PLAY' position. CD Disc
Down
Figure 3
Gear up down board
CD At 'STOCK' position.
Figure 5
CD Disc
Mark 1 Mark 3 Mark 5 (DISC 1) (DISC 3) (DISC 5) Mark 2 Mark 4 (DISC 2) (DISC 4)
Remove CD from tray. Tray eject
Figure 4 Figure 6
3�2
|
|
|
> |
|
