|
|
|
Who's Online
There currently are 6043 guests online. |
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
;
I received the Manual in a timely manner and it was exactly what I needed.
This is a perfect copy of the Service Manual, The quality is great. I am very
happy. Thank you
;
exactly as they say. Within 24 hours the link to the pages and offcourse it was the right service manual. Super and thanks
 ;
The manual was exact the thing that was promised. My old car stereo is working again thanks to the information supplied.
;
I PURHASED THIS PRODUCT BECAUSE I WAS HAVING PROBLEMS WITH MY CDR20 HARMAN KARDON RECORDER. WHICH I PURCHASED NEW 12 YEARS AGO. AFTER REVIEWING THE MANUAL, I WAS ABLE TO ADJUST THE TENSIONER IN THE SYSTEM. WORKS LIKE A CHAMP!.
SAVED ME AT LEAST 100.00 WHICH WAS WHAT A SERVICE REPAIR STATION WANTED. GREAT MANUAL EASY TO READ. SPECIALLY AFTER I PRINTED THE PAGES WHICH DEALT WITH MY RECORDER. THANKS A LOT!!!!!!!!
(2) Space around the copier
The copier requires at least 10cm of clearance between the rear side and the wall. This space is required for proper cooling fan ventilation. Adequate working space around the machine should also be allowed for ease of operation.
3 Remove tape (B) and swing the exit tray down. NOTE: Do not place any objects under the exit tray. The exit tray is linked with the fusing rollers inside the copier. When the exit tray is opened, the proper pressure for fusing toner on the paper is applied to the fusing rollers. If there is something under the exit tray and the exit tray is not fully opened during copying, a paper jam or improper fusing may occur.
(3) Power source
1 The power supply line should have a capacity of more than 15A, capable of supplying more than 90% of the rated voltage at full load. 2 Do not use an extension cord, or operate any other equipment from the same wall outlet. 4 Open the box containing the TD cartridge. Remove the TD cartridge from the bag and shake it horizontally four or five times. 5 Remove the cover from the TD cartridge.
�
Save the TD cartridge cover. It should be used to seal the TD cartridge if the copier must be shipped for servicing or if the copier is to be moved. (See page 6.)
(4) Ground connection
1 Use a properly grounded (three prong) wall outlet only.
3. Installation procedure
1 Remove the copier from the bag. 2 Press the buttons on both sides of the copier and open the front cover. Remove tape (A) to remove the spacer where the TD cartridge will be inserted.
6 Slide the TD cartridge in until it locks in place. 7 Close the front cover.
NOTE: Toner/Developer (TD) cartridge is sold separately.
�4�
|
|
|
> |
|
